Pianos consistently make movers yearly list of items that are most frequently damaged. Grand pianos are especially problematic. Practicing the following treatments for disassembling, padding and loading grand pianos will avoid damage, lower claims expenditure, and enhance client complete satisfaction.
1) At least three individuals are needed to deal with an infant grand piano. If the infant grand piano needs to increase or down stairs or if a full or show grand piano requires to be carried, a minimum of 4 individuals are required.
2) Always finish a precise and thorough stock. It may be more effective or needed to utilize a visual stock to effectively explain and show pre-existing damage.
3) As numerous parts are taken apart, please place all hardware in a properly labeled parts bag and then position the parts bag in a "Parts Box".
4) Get rid of the music rack (lyre) from its track by pulling it towards the keyboard. Wrap it in a tidy furnishings pad.
5) Detach the lid by getting rid of the hinge pins. Have one person wiggle the cover, holding it opposite the hinge, while a second person works the pin loose. Please take care not to harm the wood with the pliers or with the pin itself. If required, cover the jaws of the pliers with a small cloth to help avoid damage to the wood. Wrap the cover in a tidy furniture pad.
6) Get rid of the prop that holds the lid open and cover it in a tidy furniture pad. The prop has a hinge pin and is in 2 pieces.
7) Get rid of the pedal assembly and wrap it in a clean furniture pad. When removing the screws, please be mindful not to drop the braces. As you face the piano, number the push-rods from left to right as "1", "2", and "3", by positioning a piece of masking tape with the suitable number on each rod.
8) Pad the piano by placing a tidy rolled furniture pad (stretch-wrap the pad to avoid it from unrolling) on the cover of the keyboard to avoid it from flopping open while you deal with the piano. Keep in mind: Please make sure that the surface area of the piano is dust-free prior to padding it.
9) Position a piano board and attach the straps so that it is prepared to get the piano. The raised brace on the piano board need to be at the keyboard end of the piano.
10) Remove the left front leg by positioning one person beneath the piano at the left end of the keyboard. The other 2 individuals need to support the left front corner. The person underneath the piano must turn the keeping block so that the long end points far from the leg. The screws, if there are any, need to then be removed. The "underneath" individual should then extricate the piano before really eliminating the leg. Be sure to have two people raising the corner of the piano while the 3rd person gets rid of the leg. Keep in mind: Please make sure to note which legs were removed from which positions because some pianos have legs that are not interchangeable.
11) Location the piano on the piano board by decreasing the "leg-less" end onto the board. Please be sure to lift the whole piano slightly while completing this maneuver to prevent undue pressure on the staying, attached legs as the piano pointers. Be sure that the piano is centered snugly against the brace at the end of the piano board.
12) Get rid of Check This Out the 2 remaining legs and wrap them in clean furniture pads. These legs are kept in location by a "key and slot" arrangement. To get rid of the leg, slide it inward towards the center of the piano up until it comes out of the slot.
13) Protect the piano to the piano board by bringing the ends of the straps together and securing them. Location folded burlap pads over the furnishings pads however under the straps to supply extra defense to the edges of the piano. To avoid the strap near the narrow end of the piano from slipping off, connect the loose ends of the 2 straps together.
14) To move the piano over a flat, level surface area, tilt the piano and piano board and location a four-wheel dolly under the center of the piano board.
15) To move the piano up or down stairs, use the piano board as a skid. After sufficiently padding the stairs for security against residence damage, position the keyboard end of the piano toward the bottom of the stairs. Attach a hump strap to the top end of the piano board to avoid the piano from slipping.
16) To original site pack the piano, leave it on the piano board and place it in a tier as the first base product with the keyboard dealing with the wall of the preceding tier. The very best place to pack the padded cover is in between the piano and the preceding tier or between the piano and the wall.
Although grand pianos represent a significant obstacle, they can be check my blog moved without damage by utilizing sound judgment and practicing the treatments listed above.